Hi, I have installed 21 PLC-BUS modules. One of them is a shutter module 3160MH.
What macro commands do I need to simulate the Shutter Up, Shutter Up one step, Stop, Shutter down one step and Shutter down?
The macros will be started by a timer each.
For Shutter up I tried Scene-On
PLCBUS: SCENE-ON A1 B9 3
SYSTEM: DELAY 180000 <- This is meant as delayed stop to power off teh internal relay of the module
PLCBUS: STOP A1 B9 3
The same way for Scene-Off
What I see is various behaviour. Sometimes the stop command is not fired after 3 minutes.
Sometimes the Scene-On or Scene-Off command is not fired.
This is clearly visible in the Rx/Tx monitor.
Anyone an idea what the commands are and why the the beheaviour?