Home Automation Forum - PLC-BUS smart power line communication

Defining 3160MH
Page 1 of 1

Author:  inmar32 [ Wed 21. Dec 2011, 20:36 ]
Post subject:  Defining 3160MH

I am tring to define an address to 3160MH that i just bought.
I have 1141 interface that sends the address.
I am pressing the “Setup” button and holding for 5 seconds and the led is flickering - the unit is in setup mode.
Then i send ON to some new address and it doesnt work!

What i am doing wrong ??
Does the 1141 can support this action ?

Thank you

Author:  PLCBUSguru [ Wed 28. Dec 2011, 16:31 ]
Post subject:  Re: Defining 3160MH

It is possible to set up whole PLC-BUS system with 1141 interface.
Which software do you use?
I recommend you homeVisu for set up your system.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group